A classic American road course reduced to a single clean outline, with the low, wide profile of a mid engined American endurance racer stretched across the bottom.
Long straights, a hard left hand drop, and a car shaped entirely by what it needed to do at the end of them. Two shapes, one piece, no explanation required.
Printed as a standalone outline rather than a plaque, so the wall behind it becomes part of the design. Good above a desk, in a garage, or anywhere a flat wall needs something on it.
Specification
- Approximately 400 mm wide and 330 mm tall
- Printed in PETG, which holds its shape in a hot car, a sunlit hallway or an unheated garage where PLA would sag
- Roughly 12 mm deep, so it throws a real shadow on the wall rather than sitting flat like a print
- Choose from nine filament colours at checkout
- Ships with adhesive pads and a keyhole slot on the back, no drilling required
- Made to order on our own machines, allow 3 to 5 working days before dispatch
Each piece is printed one at a time, not moulded, so small variations in surface texture are part of it. If you would rather print it yourself, the STL file for this design is available separately in the downloads section of the shop.
